Catalogof Equiment

i-LIFE2 SLIM is the new fan coil Climaveneta, with inverter technology for heating, cooling and dehumidifying. Its elegant design with only 13
cm depth makes i-LIFE2 Slim the perfect solution for residential applications. The fan coil is also available with inverter version with radiant panel.

The brushless motor allows a perfect adaptation to thermal load, without any temperature fluctuations. Tangential fans operate through
continuous air flow modulation, with no speed steps or relay switching as traditional fan coil units. High efficiency is guaranteed in any HVAC
installation setup, in combination with any low temperature heat generator.

Controls

iKS2 - on board Control
On-board control for unit with cabinet complete with touch keypad with 8 touch key, LCD display with colored symbols. Modulating fan speed with PID logic, temperature regulation, winter/summer mode, automatic mode for the speed regulation, night mode for a silent operation. Minimum water probe and solenoid management, it's possible to manage the function even without the water probe.

ATS2 - Control with 4 speed regulation
Controller for units with cabinet. Interface with 8 keys for the temperature selection, winter/summer mode, 4 speed regulation, (Max. Min. Night and Auto) with display for room temperature vizualization. Minimum water temperature probe and solenoid valve management. It's possible to manage the function even without the water probe.

Remote Control iKSW2
Remote control for built-in and with cabinet units complete with touch keypad with 8 touch keys, LCD display with colored symbols. Modulating fan speed with PID logic, temperature regulation, winter/summer mode, automatic mode for the speed regulation, night mode for a silent operation. Minimum water probe and solenoid valve management. A maximum of 31 fancoils can be connected to the iKSW control for open space rooms. Each unit must have the iHBS2 powerboard installed. RS485 output for connection in BMS.

iHBS2 - On board semplified Control
Simple on board control for buit - in and with cabinet units, to be coupled with remote control iKSW2. iHBS2 control has a LED for the visualization of the device's operation. All the parameters are set up from iKSW2. It is possible to manage the function even without the water probe. The iHBS2 powerboard is able to supply power to IKSW2 control.

HBS2 Control - Powerboard card
Semple on board control for built-in units or with cabinet units, to be coupled with ATW Climaveneta remote control or other remote controls which manage the regulation of fixed fan speeds. HBS2 has a a LED for the visualization of the devise's operation. All the parameters are set up from the remote control. There are 2 versions of this powerboard. Version for ON/OFF signal (HBS2) and version for 0-10V signal (HBS2010)